Today is 2020-09-29 Tuesday,Welcome to this site 

Other products

FZ-1 steel ball retaining ring (copper base)

Word:[Big][Middle][Small] QR Code 2018/8/1     Viewed:    
FZ-1 steel ball retaining ring (copper base)



Product parameters
  Application features:
  FZ-1 copper-based steel ball retaining ring is made of copper alloy as the base body, and on the outer circular surface, holes with appropriate order, proper size and special shape are machined, and rolling bearing steel balls are embedded in the holes. The orifice adopts the groove circumferential locking ball process, which effectively solves the problem that the traditional point lock ball and the indentation lock ball cannot completely prevent the steel ball from falling off. The bottom of the hole is machined with a 90° stop to allow the copper ball to rotate freely within the hole without falling off. Since the diameter of the steel ball is larger than the wall thickness of the retaining ring, the steel ball is higher than the inner and outer circular surfaces of the retaining ring when in use, and directly contacts the shaft with the matching hole, so that the base body (holding ring) floats in the middle, and the matching The difference between the hole and the radius of the shaft is smaller than the diameter of the steel ball, that is, the steel ball is matched with the interference fit, the matching precision is high, and the relative movement of the shaft and the hole is flexible.
  1. Guide sleeve: Material GCrl5, YB9, heat treatment, hardness HRC62~66, technical condition according to GB/T12446 and shaft should have a radial interference of 0.01~0.02, surface roughness is
  2. Shaft: Material GCrl5, YB9, heat treatment, hardness HRC62~66, technical conditions according to GB/T12446, tolerance of shaft adopts h5, surface roughness is
  3. Measurement: The general measurement method (pneumatic gauge, outer diameter dry gauge, inner diameter dial gauge, etc.) is used to measure the dimensional deviation of the shaft guide sleeve and the steel ball, and the interference after the fitting can be obtained. Ymax=dmax+2d"-Dmin, the required interference is 0.01~0.02mm
  The product is arranged in a copper-based order at a certain angle and density and processed by a special process. The product is suitable for cold stamping dies, precision machine tools and so on.
  Technical Parameters:
  Bearing pressure: 30N/mm2;
  Assembly interference: 0.01mm~0.02mm;
  Line speed: 6m/s;
  Steel ball diameter deviation: <0.002mm<> ;
  Friction coefficient: 0.01~0.08.



  Anhui IFAG Hardware Accessories Technology Co., Ltd. provides you with: oilless bearings, sliding bearing, self-lubricating bearings, composite bearings;

  Website: www.ifagb.com


Contact us

  Anhui IFAG Hardware Accessories Technology Co., Ltd.

  Contact: Mr. Li

  TEL:182-9798-3468、0551-66559828

  URLwww.ifagb.com

  mailbox:3285504806@qq.com

  WeChat18297983468

  QQ:3285504806

  Address: No. 1188, Huaihai Avenue, Xinzhan District, Hefei, Anhui, China

Go Back
Print
[Upward]